Fan speed control is not working Inspection

[mechanics911]

Fan speed control inspection at your home or office.
Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Fan speed control is not working Inspection Service
The most likely cause of fan speed control failure is a resistor failure at the fan’s motor, although it can also be a defective control switch or burned-out fan motor.

Common reasons for this to happen:
Blower resistor malfunction
HVAC control panel is bad
Blower motor is bad
What to expect:
A top-rated mobile mechanic will come to your home or office to determine the source and cause of the fan speed control issue, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:
The mechanic will perform a thorough inspection of the HVAC system. The mechanic will check for motor operation by removing the connector and checking the condition of both male and female sides. They will probably test motor operation by connecting a battery via alligator clips to the motor’s plug pins and see if it runs direct from that source.

If the motor works fine, the next step is checking the resistor. The mechanic will unplug the resistor from its connector and check for burnt terminals. That often signifies a bad resistor. To check resistor functionality, the mechanic will use a multimeter set to the resistance function, then measure the resistances from a common point on the connector to the various pins to make sure the required Ohm values are up to spec.

The mechanic will be looking for an “open” condition (infinite resistance), which reveals a defective circuit.

Fast and easy service at your home or office

GET A QUOTE FOR YOUR CAR
Backed by 12-month, 12.000-mile guarantee